RFspace NetSDR

The RFspace NetSDR software defined wideband receiver

The NetSDR radio is a high performance networked SDR with 1.6 MHz bandwidth. The NetSDR uses a high performance 80 MHz, 16 bit ADC with both dithering and randomization for best performance. The output I/Q bandwidth is configurable via software. PC communications are handled over a 100 base-T port using 24 or 16 bit I/Q words.

The NetSDR is a complete plug and play solution. There is no need for additional preamplifiers, preselectors or code development.

Specs:

  • Frequency Range: 0.01 – 34 MHz *
  • Digital Down Converter: Xilinx FPGA
  • Synchronization : Optional Frequency Only
  • PC Interface: Ethernet 100 base-T (UDP/TCP/IP)
  • Filters: 115+ dB 80% Alias Free BW
  • Decimation Rate: Variable 40-6400 (in 4 increment)
  • Output I/Q Bandwidth: 10 KHz to 1.60 MHz *NEW* DDC Flatness: <0.5 dB
  • Dynamic Range: 104+ dB
  • MDS Preamp Off (500Hz): -129dBm 1.8 – 30 MHz
  • MDS Preamp On (500Hz): -130dBm 1.8 – 30 MHz Analog to Digital Converter: 16 bit w/ Dither
  • IQ Mute Control: Available on RS-232 Pin *NEW* Preselection: 10 Filters
  • Attenuators: 0, -10dB, -20dB, -30dB
  • Sample Rate: 80.000 000 MHz
  • Memory: 65536 x 16 bit samples
  • External Radio Control: Built-in RS-232 port
  • Dimensions: 8” x 6” x 1.5”
  • Power: 5 Volts DC @ 1.5 Amp **
  • Connections: 3 x BNC (RF In, Ext Ref, IF Out) , RS-232, USB Setup, Stereo In, Ethernet, Power, RX Mute.
  • Compliance: CE,FCC,IC
  • Ethernet Bandwidth Requirements:
    • 2.00 MHz Output Sample Rate = 64.0Mb/s*16bit IQ
    • 1.00 MHz Output Sample Rate = 48.0Mb/s*24bit IQ 0.50 MHz Output Sample Rate = 24.0Mb/s*24bit IQ 0.01 MHz Output Sample Rate = 0.60Mb/s*24bit IQ

Resources:

This entry was posted in Made in USA, RFSpace, Software-Defined Radios (SDR) and tagged , , , , , . Bookmark the permalink.