Turning the Raspberry Pi 3 B+ into a stand-alone SDR

(Source: RTL-SDR.com)

Nexmon SDR: Using the WiFi chip on a Raspberry Pi 3B+ as a TX capable SDR

Back in March of this year we posted about Nexmon SDR which is code that you can use to turn a Broadcom BCM4339 802.11ac WiFi chip into a TX capable SDR that is capable of transmitting any arbitrary signal from IQ data within the 2.4 GHz and 5 GHz WiFi bands. In commercial devices the BCM4339 was most commonly found in the Nexus 5 smartphone.

Recently Nexmon have tweeted that their code now supports the BCM43455c0 which is the WiFi chip used in the recently released Raspberry Pi 3B+. They write that the previous Raspberry Pi 3B (non-plus) cannot be used with Nexmon as it only has 802.11n, but since the 3B+ has 802.11ac Nexmon is compatible.

Combined with RPiTX which is a Raspberry Pi tool for transmitting arbitrary RF signals using a GPIO pin between 5 kHz to 1500 MHz, the Raspberry Pi 3B+ may end up becoming a versatile low cost TX SDR just on it’s own.[…]

Click here to read the full article at RTL-SDR.com.

Spread the radio love

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.