Andy seeks advice on directly coupling an AM loop antenna to a crystal radio

Andy would like to couple a similar antenna to a crystal receiver

Many thanks to SWLing Post contributor, Andy, who asks the following question in response to a previous post about building a Milk Crate AM Broadcast Loop Antenna:

All references to tuned loop antennas talk about no real connection to the AM radio, but merely inductive coupling.

However, I made a very elementary crystal radio which has no ferrite core or antenna.

I want this loop to be my primary (only) antenna, so I need to feed it directly to my tuning circuit. So I don’t know if I should take a wire from any particular part of the loop, with another wire to ground… and if these 2 wires should be in parallel or series with the tuning elements of the loop antenna.

Thanks!

Good question, Andy! Hopefully someone in the SWLing Post community can comment with some guidance!

Spread the radio love

7 thoughts on “Andy seeks advice on directly coupling an AM loop antenna to a crystal radio

  1. Raphael Pollock

    It is quite easy to do, actually. I presume that you have high impedance ear phones or headset. It is easiest to set up using those little connector wires that have alligator clips on each end. Use these to connect the rotor as well as the stator of your variable capacitor to each of the leads on your head set. Interpose an appropriate diode (IN34a) between either the stator or the rotor and one of the leads of your head set. So three alligator clip patch cords, a high impedance head set, and IN34a diode is all you need and you are in business. I use mine to listen to all seven of the local AM stations here in Columbus, OH. I have a vernier dial attached to the variable capacitor; between using that for fine tuning and the ability to rotate the loop I can null out any of the seven stations and will hope for some dx, especially if I attach a long wire antenna and use the loop as an antenna tuner…

    Reply
  2. Bruce McCreath

    Try replacing the coil of your crystal set with the loop antenna itself. It will serve two purposes, the first being the L of the L-C tuned circuit, and the second will be its function as the antenna. You may have to add or subtract turns to get it to tune the frequencies of interest. You could also vary the value of your tuning capacitor by using several of its sections in parallel.

    Reply
  3. Zack Schindler

    I would like to build one of these to use with my ICF-S5W. Is 20 turns optimal for 530-1700khz?

    Zack N8FNR

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.