Tag Archives: Radio Station of Macedonia

Shortwave Radio Recordings: ERT Open (Voice of Greece)

As I prepare the largest post I’ve ever published on the SWLing Post—a review and comparison of the PL-660, PL-880, ATS-909X and ICF-SW7600GR–I’ve been listening to the music I recorded Sunday night on ERT Open (Voice of Greece).

Regular readers know that I’ve always had a particular fondness of this station. Some nights they play hour long sets of music ranging from folk to modern (I especially love the folk) on 9,420 kHz. Their signal booms into North America as well; indeed, ERT Open can even be heard on a basic shortwave portable with relative ease.

Since I don’t speak or understand the Greek language, I can listen to this music while writing posts and catching up on email correspondence (I’m terribly behind at the moment).

For your listening pleasure: two hours, six minutes of ERT Open recorded on July 6, 2014 staring around 01:00 UTC.

Click here to download the recording as an MP3, or simply listen via the embedded player below:

If you’re interested in the benchmark portable radio review I mentioned above, check back on the SWLing Post later today.

Spread the radio love

Shortwave Radio Recordings: the Voice of Greece, one year on

1 Reply

Last night, while learning the ropes of the new Elad FDM-S2, I noticed some great music on 9,420 kHz, the former Voice of Greece frequency.

GREECE-ECONOMY-MEDIA It was then that I realized yesterday (June 11) marked the one year anniversary of the day that the Greek government shut down ERT and the Voice of Greece. If interested, click here for some audio I recorded that very night.

Amazingly, one year later, 9,420 kHz is still active out of the Avlis transmitter site and last night, the Radio Station of Macedonia (a.k.a., ERT 3) was playing an excellent mix of Greek music and jazz.

Click here to listen to the 51 minute recording, made with the Elad FDM-S2 software defined receiver, starting at 00:50 UTC:

You’ll note great audio fidelity and a low noise floor despite the numerous static crashes present from area thunderstorms. (Note that I did not have DSP noise reduction nor the noise blanker engaged.) I started the recording in standard AM mode, then changed it to AM synchronous detection between songs in the first half of the recording.

Spread the radio love

The Elad FDM-S2 SDR: Unboxing, installing, and a first recording

8 Replies

At the Dayton Hamvention last month, I made a point to check out the Italian radio manufacturer, Elad. Though I’ve known about Elad for some time, I hadn’t investigated their offerings yet simply because I was under the impression they only sold and warrantied their equipment within Europe. Fortunately, Elad has begun supporting and shipping their products within the US, via their division Elad-USA.

The Elad USA table at the 2014 Dayton Hamvention

Elad’s booth was one of the first stops I made at the Hamvention; I met with their representatives there, who answered my many questions. While Elad is soon to release their flagship tabletop SDR transceiver (the FDM-DUO, see below), I was more interested in their flagship receiver, the FDM-S2–which really impressed me during their demo.

The FDM-DUO attracted a lot of attention at the Elad booth.

The FDM-DUO attracted many visitors at the Elad booth.

Yesterday, I unpacked a loaner FDM-S2 Elad sent for review; this review will be published first in The Spectrum Monitor magazine, and following, here on the SWLing Post. While it will take some time to piece together a full review for TSM, I thought I would periodically post recordings (and note FDM-S2 features) I discover along the way…

Unboxing the FDM-S2

Being a receiver with a small footprint (a major plus, in my world), the FDM-S2 comes in a small box (measuring only 6.5 x 5.5 x 2 inches).

Contents of the box are few and simple: the FDM-S2 receiver, a black cloth carrying bag, and a 4GB USB drive with installation software and documentation. A standard USB cable was also included in the shipping box.

FDM-S2-Box-Contents

The FDM-S2 metal enclosure is beautifully engineered, and feels of excellent quality in my hands.

Installation

I found installation of the Elad FDM-S2 to be fairly straightforward. However, I would encourage you to follow the included guide, since installation is a two-step process:

First, you install a C++ package on your Windows PC which, when complete, triggers the actual Elad software installation: this is a two-part installation that you only initiate once.
Secondly, you install the USB driver for the FDM-S2, found in the installation folder of the supplied software. At time of posting, the USB driver cannot be automatically discovered and installed by your PC; you must initiate the installation via the device manager. However, this is very easy: the guide takes you through the process step-by-step.

On the back of the FDM-S2 you'll find an HF and VHF SMA antenna ports, a USB port, serial interface, and on/off switch.

On the back of the FDM-S2 you’ll find HF and VHF (SMA) antenna ports, a USB port, serial interface, and on/off switch.

The FDM-S2 derives its power from the same USB cable that is used for data, no separate external power supply required–a huge plus, for those of us who like to travel.

Once I installed the software and driver, I hooked up my antenna to the HF SMA connector on the back, turned on the FDM-S2, and launched the application. The FDM-S2 clicked to life, and the application ran on the first go: very nice!

I spent a good hour or so familiarizing myself with the Elad software yesterday evening. It’s quite a departure from the WinRadio Excalibur and Microtelecom Perseus applications with which I’m most familiar. Nonetheless, while I’m still learning how to adjust the spectrum bandwidth (which can be a full 6 MHz wide!) plus manage the four virtual receivers, I found I was able to do quite a bit of band-scanning.

In fact, I noticed some great music on 9,420 kHz, the former Voice of Greece frequency:

FDM-S2-Waterfall

I initiated my very first AF recording on the FDM-S2 (see screen capture above). The process was quite simple and I’m very happy with the level of customization Elad affords in its software; indeed, I can set the file name to automatically note the frequency, time, date and mode.

Click here to listen to that recording in the recent post, The Voice of Greece, one year on.

Day One with the FDM-S2? So far, so good. The Elad application is very customizable, hence has a higher learning curve than SDR applications I’ve used in the past. Thus I’ll need to log quite a few hours on the FDM-S2 before I can say that I’m proficient.

Readers: Have you had experience with the FDM-S2? Any hints or suggestions? Please comment–!

Spread the radio love

Shortwave Radio Recordings: Radio Station of Macedonia (Voice of Greece)

Shortwave Radio Recordings: Radio Station of Macedonia (VOG)

1 Reply

For your listening pleasure: 1 hour 29 minutes of The Radio Station of Macedonia (formerly Voice of Greece). This broadcast was recorded on January 28, 2014 around 1:50 UTC on 9,420 kHz.

During much of the month of December (2013), the Avlis transmitter on 9,420 kHz was off line. Since its return, modulation (as you’ll here) is not quite as good as before. Still, the signal is strong and I’m happy it’s active, even though purely a relay of ERT 3, the Radio Station of Macedonia.

Click here to download the recording as an MP3, or simply listen via the embedded player below:

Spread the radio love

A little gift (for you) that keeps on ringing…

4 Replies

With a nod to the holidays, I thought I’d give a little gift to my readers– just in time to ring in the New Year, too.

One of the quirkier radio experiments I’ve made recently is to create ringtones based shortwave station IDs and interval signals. My favorite, thus far, is that of the Voice of Greece (a.k.a. Radio Station of Macedonia) because it has the hallmarks of a great ringtone: it starts very quietly (giving you time to turn it off if you left it off in a meeting) and is distinctive from practically any other ringtone on the planet. It’s also loud enough to get your attention. Yet it’s wonderfully humble, suggesting a halcyon locale–a shepherd’s pan pipe underscored by the gentle arrhythmic ring of goats’ bells. A Greek vacation in every ring.

I’ve had the Voice of Greece as my ringtone long enough that I was recently listening when the VOG ID hit the radio, and my daughter called out, “Daddy! Your phone is ringing!”

If you would like my VOG ringtone, it’s yours–free! {Merry Christmas! Happy Holidays!}

I have links to two formats below: one for iOS and one for Android. Simply right click and save the file to your computer.

Click here to download the iPhone (iOS) version. If you have an iPhone, simply import the downloaded file into iTunes on your PC/Mac. It should recognize the file as a ringtone and place it in your “Tones” category. Once you sync your phone, it should appear in your ringtones on your phone.

Click here to download the Android version. Instructions for adding the ringtone to your Android phone can be found here.

Now, if you’d like to hear something a little more festive than a ringtone, I’d encourage you to listen to this studio recording of beHAVior Night on the SW Radio Audio Archive.

“Sir Scratchy” has kindly shared this with us.

Enjoy!

Spread the radio love