Category Archives: Shortwave Radio

Hearing shortwave on the Sony SRF-59 AM/FM walkman

The Sony SRF-59

The Sony SRF-59

SWLing Post reader, Steve, writes:

I check in on your blog frequently. I’ve been a casual SW and AM dxer since my childhood. I’m a mechanical engineer, and have some basic electronics knowledge, but I’m no RF expert, and half forgot most of what I used to know.

On 9-13-15, around 11am eastern time, I was playing with a Sony SRF-59 down low on the AM band. The lowest station I can hear at my location near Valley Forge PA is a Spanish language station on 540–WLIE, on Long Island I think. My dial is badly calibrated but I know I was below that station on 540, maybe even below 530 or 520, and heard some noise. It took some really careful back and forth tuning, but I could hear a voice. I put the radio against my AN200 passive loop and heard the clear unmistakable voice of “Brother Scare”, (Overcomer Ministry). I scanned the shortwave and found a simulcast on 9840, WHRI Cypress Creek SC. The info I have says it’s a 250 kW broadcast.

Grundig AN200 Loop Antenna

Grundig AN200 Loop Antenna

I scratched my head and thought there must be a pirate rebroadcasting it on the bottom of the AM band, but I couldn’t hear it on my CC 2E, or my Grundig G3 which tunes continuously from LW into MW. It is really touchy to tune on the SRF-59, but with work, I could hear him barefoot, and very cleanly with the loop. I checked in several times the next few hours and it was there until WHRI went off the air at 3pm I think. Unfortunately, I never got a station ID.

On the morning of Monday Sept 14, at 9pm local time, with the same radio and loop, I got a station ID for China Radio International, and then found the same broadcast on 9570 from Quivican Cuba–also a 250 kW signal. I could not hear it clearly barefoot, as with WHRI, (it is quite a bit more distant) but with the loop is was incredibly clear. Also it doesn’t seem to matter where the tuning dial on the loop is, or how it’s oriented (I was aimed east/west). The radio and loop both function normally higher up the AM band (you need to tune the loop, and the reception is amazing with it).

I know I was below 540, because I passed local stations on the way down–610(WIP), and 560 (WFIL)–and could hear Spanish voice just below that, which had to be 540. The shortwave was just below that. The only thing i get below that on any other AM radio is Cuba and Canada on 530, both of which I can obviously only get at night time. I don’t know how the tuning circuits could jump 9mHz so suddenly.

Call me mystified. I thought I could find something about this on the net; I can’t be the only one with this experience; but no. Have you ever heard of this?

Steve followed up later noting that he is actually able to tune in the whole 31 meter band, as long as a signal is strong enough to overload the SRF-59.

I’ve done a lot of MW DXing with the SRF-59 and had never noticed harmonics, but I’m not surprised they can be heard either. I might try to replicate what Steve did using my AN200 loop coupled to the SRF-59.

Has anyone else as heard 31 meter band signals on their SRF-59?

The Mighty KBC test broadcast September 27

DJ Eric van Willegen, "Uncle Eric" hosts The Giant Jukebox on the Mighty KBC.

DJ Eric van Willegen, “Uncle Eric” hosts The Giant Jukebox on the Mighty KBC.

(Source: The Mighty KBC)

For our listeners across the pond:

Uncle Eric is testing Saturday September 26th on 7395 kHz between 23:00 – 24:00 UTC.

Our normal broadcast on 7375 kHz is on Sunday September 27th 00:00 – 03:00 UTC.

Please spread the word and send your reports for 7395 kHz.

Does the Tecsun PL-880 have a hidden ETM function?

PL-880-ETM-Display

SWLing Post reader, Claudiu, writes:

I have a question regarding the ETM (Easy Tuning Mode) function on the Tecsun PL-880 model. Its indicator is visible on the LCD screen [see above], but I couldn’t find any mention of this function for this model. What should one do to enable that indicator and use the function? I’ve seen mention of this for earlier models (PL-380/PL-390), but not for PL-880, even after looking over the hidden features. Do you, or your followers, have any idea on this?

Very good question–it would be nice if the PL-880 had a hidden ETM function, but I suspect the PL-880 may simply use a stock Tecsun display; “ETM” may be standard print.

By chance, has anyone discovered a hidden ETM function on the Tecsun PL-880? If so, please comment.

Buying a shortwave radio in India?

Tecsun-PL660

SWLing Post reader, Muthu Kumar recently asked if I knew of a good source of shortwave radios–specifically, the Tecsun brand–in India.

I’m asked this very question at least a few times each year and have always replied that eBay may be the best option.

I’m curious if any of our readers living in India have good suggestions of shortwave retailers either within the country or who ship to India without many hassles. Please comment.

Shortwave Archive featured in The Wire Magazine

TheWire

We’re absolutely chuffed to learn that the Shortwave Radio Audio Archive (SRAA) has made the pages of the October 2015 issue of the British alt music magazine, The Wire Following are two excerpts from the brief but powerful column by Richard Thomas:

The Wire
October 2015 (Issue 380)
Page 17

Thomas continues in this vein, his descriptions of the varied content inviting readers to immerse themselves in the SRAA’s static-infused depths.

Finally, Thomas concludes by describing in terms no less than lyrical exactly why he responds–as so many do, myself included–to the recordings found in the archive:

The Wire
October 2015 (Issue 380)
Page 17

Wow…what a testament to the power of sound.  Thanks, Richard and The Wire–we’re humbly grateful that someone shares our passion for this growing project.

And if you haven’t checked out the SRAA yet, take some time to do so; you won’t regret it.  Contributions are welcome.

Dave unveils the Sproutie MK II regenerative receiver

SproutieMKII

My talented pal, Dave Richards, has built yet another home-brew regenerative receiver––which he dubs the Sproutie MK II––and wow, it’s a thing of beauty.

Dave tells me has been working on this receiver for many months, and upon viewing the following photos of it, it’s clear to see why he took his sweet time. As in his original Sproutie, a vintage HRO dial has taken pride of place as the centerpiece of his rig; it looks stunning.

But the Sproutie MK II is not only painstakingly-crafted on the outside; like Shaker furnishings, wrought for the eyes of God both outwardly and within, the interior of Dave’s receiver is equally well-crafted.

Okay, maybe that’s a little over the top…but if you doubt me, just join me in admiration of this board:

SproutieMKII-board

As for performance?  Of course, with such a clean interior, the Sproutie II performs like a champ.  Dave posted a few videos showing how his new receiver commands the airwaves and aptly handles AM, SSB, and CW.

That’s an amazing piece of kit you’ve created there, Dave!  Hats off to your incredible craftsmanship.

Check out Sproutie II on Dave’s blog, where you can read a full account of how he designed and built this gorgeous regen receiver.

Shortwave Radio Recordings: VOA on the 10th anniversary of Apollo 11 moon landing

Apollo_11_lunar_module-001

Many thanks to SWLing Post and SRAA contributor, Tom Laskowski, who shares this recording of the Voice of America; recorded on July 20, 1979 at 0500 UTC on the 31 meter band. Tom notes:

“The first 4:30 is from a VOA newscast that aired before the main part of the program. The main recording was presented on the 10th anniversary of the Apollo 11 moon landing. I enjoy listening to this every year on the landing anniversary.”

Click here to download the recording as an MP3, or simply listen via the embedded player below:

Note that Tom has been sharing a number of shortwave recordings from the late 1970s. All of his recordings are being published on the Shortwave Radio Audio Archive. Tom: thanks so much for being a part of the shortwave archive community.

If you have recordings you would like to share with the world as well, please contact me.