Category Archives: Guest Posts

Guest Post: An Introduction to DXing the MF Marine Bands

Many thanks to SWLing Post contributor, Don Moore–author of Following Ghosts in Northern Peru–for the following guest post:

Monitoring the MF Marine Bands

By Don Moore

For me, DXing has always been about the challenge of receiving difficult-to-hear radio stations, regardless of the type of station or frequency range. In my five decades in the radio hobby I’ve logged a lot of different kinds of stations – shortwave broadcast, medium wave, shortwave utility, longwave beacons, etc. But some of my favorite catches have been in the upper end of the medium frequency range.

Technically speaking, medium frequency (MF) is the range from 300 to 3000 kHz and includes the standard medium wave (AM) broadcast band. The upper end of the MF band, from 1600 to 3000 kHz (except for a small portion reserved for amateur radio), has always been assigned to various types of utility uses including broadcasts and other voice communications from regional maritime stations. And while digital modes and satellites have done a lot to change the nature of communication with ships at sea, there is still a lot of good human-voice DX to be heard.

Several dozen stations, mostly in Europe and North America, broadcast regularly scheduled marine information broadcasts in the MF range. These broadcasts are usually between five to ten minutes in length and include weather forecasts, navigational warnings, and other notices to keep ships at sea safe. On occasion it’s possible to hear two-way voice communication here between ships and shore stations, although that’s much less common today.

The Equipment

Nothing special is needed to DX the marine MF band other than a receiver that covers the frequency range and can receive USB mode (which all these broadcasts are in). However, for reasons explained below, I highly recommend using an SDR to make spectrum recordings of the entire band to go through later. Continue reading →

Spread the radio love

Airspy HF+ Discovery & Shortwave Portables: Having Fun with the Airspy YouLoop!

20 Replies

Many thanks to SWLing Post contributor, Bill Hemphill, who shares the following guest post:

YouLoop Antenna Fun

by Billy Hemphill WD9EQD

Like many listeners, I live in an antenna restricted community. While I have strung up some hidden outdoor wire antennas, I have found that they didn’t really perform that much better than just using the telescoping antenna with maybe a length of wire attached. The biggest problem (whether indoor or outdoor antenna) has been the high noise floor.

A few months ago I bought an AirSpy HF+ Discovery SDR receiver. I had already owned a couple of SDRPlay SDR receivers, but the high noise floor limited their performance. I had read good reviews about the AirSpy, especially its performance on the AM Broadcast band and the lower shortwave bands.

I have about 80 feet of speaker wire strung from the second floor and across the high windows in the living room. This does perform fairly well, but the high noise floor still exists.

A couple of weeks ago, I bought the YouLoop Magnetic Loop antenna from AirSpy. I gave it a try and am amazed at the lower noise floor compared to the indoor wire antenna.

Wire Antenna vs. YouLoop–some examples:

AirSpy with Wire Antenna

AirSpy with YouLoop

AirSpy with Wire Antenna

AirSpy with YouLoop

AirSpy with Wire Antenna

AirSpy with YouLoop

Dramatic reduction in the noise floor. I’ve done a lot of playing around with it and find that the YouLoop picks up just about the same stations as the indoor wire antenna does. But with the lower noise level, the YouLoop makes it more enjoyable to listen. Overall, the YouLoop is now my main antenna.

YouLoop with a Portable Radio

It works so well with the AirSpy, I started wondering if I could use it with a portable radio, like the Tecsun PL-880. But the AirSpy website has the following note:

Note: It is very likely your third party radio will not be sensitive enough to operate with the YouLoop properly. We have even seen self-documented failed attempts to build pre-amplifiers to compensate for the lack of sensitivity and/or the required dynamic range in third party radios. Use your brain, and eventually an Airspy HF+ Discovery.

Doesn’t sound like it will work with portable radios. BUT, I’m always one to try anyway.

Tecsun PL-880

Since the YouLoop has a SMA connector, I bought a SMA to 1/8” phone jack cable. Plugged it into the PL-880 antenna jack and found I had almost a dead radio. Very few stations heard. But in playing around, I accidentally touched the phone plug to the telescoping antenna and instantly got strong signals.

I did some very unscientific tests. I attached the YouLoop through the side antenna jack, did an ATS scan, then did the same with the YouLoop clipped to the telescoping antenna. Also did a scan with just the telescoping antenna fully extended.. I got some very interesting results. These were done one after the other, so there can be differences in signal fading, etc.

I have repeated the above test several times at different hours. While the actual number of ATS stations varied, the ratio between them remained fairly consistent to the above numbers.

From the above, it appears that the telescoping antenna circuit is more sensitive than the 1/8” antenna jack circuit. Maybe some attenuation is being added to the 1/8” jack since it’s more likely a higher gain antenna would be used there. Can anyone confirm that the circuit indeed attenuates thru the antenna jack?

The YouLoop seems to be a decent performer when directly clipped to the telescoping antenna. While not as good as a high gain outdoor antenna would be, it definitely is usable for indoor uses.

I also tested it clipped to the antennas of some other portable receivers. Tecsun S-8800, PL-330, Panasonic RF-2200 and Philco T-9 Trans-World receivers. All showed an increase over just using the telescoping antenna.

Some interesting notes:

The Tecsun PL-330 saw the same reduction in signal when directly plugged into the antenna jack as opposed to clipping on the telescoping antenna.

The Tecsun S-8800 did not show that much of a drop. I basically got the same number of stations when clipped to antenna as when I connected to the BNC jack:

In conclusion, I find that I can use the YouLoop with my portable radios to increase the signals on strong stations when used indoors. And it is quite the performer when used with the AirSpy HF+ Discovery SDR receiver. It easily portable and I find that I move it around the house as I need to. I just hang it off a window curtain rod. I may just order a second one so that my family room radio has one permanently attached to it.

Click here to check out the Youloop at Airspy.com.

Spread the radio love

Guest Post: Don targets rare Norwegian stations during Newfoundland DXpedition

13 Replies

Photo by the Bjørnøya Meteorologiske Stasjon

Many thanks to SWLing Post contributor, Don Moore–author of Following Ghosts in Northern Peru–for the following guest post:

The Rarest DX?

By Don Moore

In mid-October I received an invitation to attend the annual DXpedition in Cappahayden, Newfoundland with Jean Burnell, John Fisher, and Jim Renfrews. It didn’t take long for me to say yes. Newfoundland is one of the best places in the world to DX from and all kinds of amazing stuff has been heard there. I was excited at the prospect of great medium wave DX and being able to log low-powered European private and pirate shortwave broadcasters.

But something else was at the top of my try-for list. One of my many DX interests has always been logging coastal marine stations in the 1600 to 3000 kHz range. In preparation I started checking online sources to update my spreadsheet of schedules. In going through a recently added section on Marine Broadcasts in the DX Info Centre website I came across listings for twice-daily weather broadcasts from Hopen Island on 1750 kHz and Bjørnøya (Bear Island) on 1757 kHz.

I didn’t remember ever seeing anything about broadcasts from these remote islands in the Norwegian Arctic before. Were these stations actually on the air, I wondered. And if they were, could I hear them in Newfoundland? Continue reading →

Spread the radio love

Guest Post: Peter’s FM CB Update

18 Replies

Many thanks to SWLing Post contributor, Peter Laws, who shares the following guest post:

Thomas – Still Famous

by Peter Laws

We’re getting closer to the first legal FM CB on the market in the USA. President Electronics USA has announced that the President Thomas FCC CB radio will hit dealers in early 2022.

When first reporting on this, the assumption was that the Thomas FCC was going to be an FCC-spec Thomas ASC, a somewhat long in the tooth European multi-norm set. As the release date has approached, and President has released marketing collateral, it’s apparent that this new product is, in fact, a rebranded President Barry II, a current-production state-of-the-CB-art AM/FM European multi-norm model.

Richard, G0OJF, a pipe organ restoration and two-way radio expert from Lincolnshire, England, runs a wonderful YouTube channel “UK FM CB radio servicing”, where he restores old UK-spec CBs and then tests them on air. He also tunes up newly-released UK-spec CBs … and occasionally demonstrates restoration of 150-year-old pipe organs. He recently covered the Barry II so if you are curious about the Thomas FCC you are strongly encouraged to watch his video about its European counterpart.

Your humble reporter, who, perhaps surprisingly, has not followed the CB radio market since, (checks notes), 1977 or so, was amazed to see that the MSRP will be $109. In 1976 terms, that’s just under 25 bucks and had CBs been that price then, your reporter would have bought three because he’d been saving his pennies and that was the amount he’d saved!

Undoubtedly, the reduction in cost is from using components that are readily assembled by robots. If you watch G0OJF’s video above, you’ll note that the unit is almost completely made of surface-mount components. Remarkable.

Watch for dealers to begin offering these in the next few weeks. Your reporter plans to buy one and will be hanging out on Channel 31 FM once it’s installed in his radio room. Presumably, President (and other vendors) will be watching to see how these units sell in order to make plans for releasing other CBs that include FM. An AM/FM/SSB CB would be quite versatile!

Let’s play a game: Spot the differences!

Full manuals for both versions are here:

President Thomas FCC operating manual

President Barry II operating manual

Spread the radio love

Guest Post: Pavel’s Homebrew “Monster” Drain Pipe FSL Antenna

16 Replies

Many thanks to SWLing Post contributor, Pavel Kraus, for the following guest post:

Building a Drain Pipe FSL Antenna

by Pavel Kraus

Hi, I greet all DX fans and the entire SWLing Post community! I enjoy reading reading this blog and the diversity of contributions from our authors and contributors; many thanks from me for so much useful information.

The following are the construction notes of my FSL antenna, which I designed thanks to the suggestions of GaryDeBock, and other FSL designers.

The antenna is a classic design featuring 60 ferrite rods 200x 10 mm, which are placed on a plastic sewage pipe.

Pict 3: Pipe with ferrite rods and windings

Pict 4: Pipe with ferrite rods and windings

In addition, sewer pipe sections are used for the entire antenna cover. I assume that this material can be obtained in other countries as well. Continue reading →

Spread the radio love

Giuseppe’s Homemade “Magic Tablet” Antenna System

6 Replies

Many thanks to SWLing Post contributor, Giuseppe Morlè, who writes:

Dear Thomas,

This is Giuseppe Morlè, from Formia central Italy on the Tyrrhenian Sea,

I built this “Magic Tablet. during a rainy afternoon to test various portables I have.

The tablet is composed of 2 separate circuits: one for the short waves, a single coil along the entire perimeter of the tablet, and another with 2 ferrites wrapped around 36 turns of telephone cable for the medium waves.

The heart of the system is a 1050 pf variable capacitor with its old wheel.

To listen to medium wave I have to exclude the short wave loop with a switch on the loop.

I also added another small switch to connect it to a capacitor for more or less capacity, but this I will do later.

I can test my portables like this because the tablet tunes very well from 500 kHz to 18 MHz. I spent very little to make all this as it is all recycled stuff.

You can see the first tests on the balcony of my house with a Tecsun H-501 via my YouTube channel:

Note: this video is in Italian, but you can turn on closed captions and have it translate into the language of your choice.

As I always say, I am not a technician and I have little manual skills in building things, not having a proper laboratory. When I get an idea, I put it on paper and I start to find all the materials and then see if they work. Not all of us are of the experts in electronics–what drives me is a passion for radio listening. Now being retired, I have more time to devote to it.

Thanks to you and hello to the whole SWLing Post community …

73. Giuseppe Morlè (IZ0GZW)

I love this, Giuseppe! What a clever all-in-one portable antenna system for your shortwave radios. I especially love the fact you were able to create all of this from parts you have at your home. You’ve got a winning attitude, too: build and experiment! Thank you for sharing.

Spread the radio love

Jock explores “The Essential Listening Post”

24 Replies

Many thanks to SWLing Post contributor, Jock Elliott, who shares the following guest post:

The Essential Listening Post

By Jock Elliott, KB2GOM

Listening to shortwave radio (or any radio, for that matter) is just plain fun.

So what do you need to get in on the fun?

A radio. With today’s crop of portable SW radios, many of which have search and store capabilities, a newbie SWL can get started quickly without a lot fuss and bother and no extra stuff. Just hit the search and store function (it has different names on different radios), let the search function do its thing, and step through the memories to see what’s out there. If your radio doesn’t have search and store, you can just tune around to see what’s currently broadcasting or, if you have a computer or smart phone, use it to explore one of the online directories like https://shortwaveschedule.com/

What follow next are some things that I’ve found increase my enjoyment of SWLing. Continue reading →

Spread the radio love