Fessenden Christmas Eve Commemorative Transmissions

Embedded image permalink

This was reported in the ARRL Newsletter:

Brian Justin, WA1ZMS, will again put his 600 meter Experimental Station WG2XFQ on the air on for a Christmas Eve commemorative transmission. WG2XFQ will transmit on 486 kHz from Forest, Virginia, to mark the 109th anniversary of Reginald Fessenden’s first audio transmission. Historic accounts say Fessenden played the violin — or a recording — and read a brief Bible verse. It’s been reported that other radio experimenters and shipboard operators who heard Fessenden’s broadcast were astounded.

Justin will conduct a run-up to this year’s event starting at around mid-day Eastern Time on December 23. The “official” Christmas event will begin on December 24 at 0001 UTC (the evening of December 23 in US time zones) and will continue for at least 24 hours. Justin said he plans to repeat the commemorative transmissions on New Year’s Eve and on New Year’s Day.

Fessenden’s transmitter was an ac alternator, modulated by placing carbon microphones in series with the antenna feed line. Justin’s homebuilt station is slightly more modern, based on a 1921 vacuum tube master oscillator power amplifier (MOPA) design. Listener reports are appreciated and may be sent directly to Brian Justin, WA1ZMS, at his QRZ.com address. (Brian Justin, WA1ZMS, built this replica circa-1920 transmitter, capable of CW and Heising modulated AM. Photo by Brian Justin)

While I have not heard Brian’s transmission before, I have actually heard a transmission on the experimental frequencies between 465 – 515 kHz. I never expected to be able to hear anything due to extremely high local noise, but one night the propagation gods smiled upon me and the evening was exceptionally quiet. I listened on my Elad SDR receiver over and over to the Morse Code signal which was extremely weak, but mostly readable. I confirmed with Multipsk software, verifying I was indeed hearing one of the experimental stations out of Connecticut.

For information regarding the 500 KC experimental project you can follow this link.

Why not give a listen? You just might be surprised like I was to hear something on this band, and you could add a little Christmas Eve radio memory to your collection!! 73, Robert

Robert Gulley, AK3Q, is the author of this post and a regular contributor to the SWLing Post. Robert also blogs at All Things Radio.

WTWW Christmas Shortwave Radio Picture Contest

2 Replies

Yes, though I'm not entering the contest, I am getting into the spirit of the season!

Though I’m not entering the WTWW contest, I *am* getting into the spirit of things!

(Source: WTWW via David Korchin, K2WNW)

It’s Christmas music on International Shortwave Radio Station WTWW. We want the shortwave radio to take the place of the electric train under the Christmas Tree! We are asking for pictures of your shortwave radios – the most festive picture wins! Include yourself, friends and family, include the Christmas tree, or deck your radio with boughs of Holly and all things Christmas!

Send your pictures to email@wtww.us for the chance to win the Grand Prize – a TW 2010 Antenna complete with the quadra stand and custom carry bag! During the week we are starting on 5085 kHz at 7pm CST until 11pm CST. On the weekends we are starting at 1pm CST on 9930 kHz until 7pm when we change to 5085 kHz and it will go until late into the night.

Blow the dust off of those classic radios and get them out of the closet or attic and Tune In for Bing Crosby, Montovani, Dean Martin, Burl Ives, Mannheim Steamroller and many more. There is nothing like the sound of Christmas music coming out of the speaker of a classic shortwave radio.

We will even accept creative pictures of not so classic radios and newer radios including SDR’s that look festive and capture the spirit of Christmas. We also love and welcome videos with WTWW playing in the background. If you think your radio can make Santa smile, then send us your picture – you could be our big winner! Other prizes will be announced as we go along.

email@wtww.us

or

WTWW
P.O. Box 102
Lebanon, TN 37088

Wired: Inside Bang & Olufsen

1 Reply

Beolit 39 from 1938, B&O’s first Radio in Bakelite (Source: Wikipedia, image by Theredmonkey)

On the topic of beautiful radio design, I just read this Wired Magazine article which features photographer, Alastair Philip Wiper.

Wiper has been researching the Danish consumer electronics company Bang & Olufsen for his upcoming book, The Art of Impossible: The Bang & Olufsen Story. He was granted unprecedented behind-the-scenes access to B&O, where he learned about the company’s design philosophy, process and history. Here’s a short excerpt from the article:

“In the mid-1950s, design greats like Arne Jacobsen began experimenting with new materials and colors, galvanizing a wave of mid-century modern Danish furniture makers. Everything was sleek, teak, and handsome—it still is—but exhibits showing off the new pieces had a curatorial problem: no one was making modern radio cabinets, forcing curators to display decidedly outdated designs alongside the stylish new furniture. The technology definitely needed a major overhaul.

Bang & Olufsen joined a handful of radio manufacturers in rising to the challenge. The two men spent a few years doing research and working with architects and designers to design devices as beautiful as they were functional—an approach widely taken for granted today but novel at the time[..]”

I encourage you to read the full article at Wired.com and view some of the photographs in their online gallery. If you’re not familiar with B&O design, do a simple image search online.

Video: How The Teleprinter Works (1940)

1 Reply

Telegraph

(Source: Stephen, G7VFY, via the Southgate ARC)

Produced by the GPO Film Unit. Models are used to demonstrate the working of a teleprinter. Shown is how the pressing of a key on the keyboard generates a five unit teleprinter code, is then transmitted as a serial code to the teleprinter line and finally is decoded to select the correct character on the type wheel of the printing mechanism of the receiving teleprinter.

https://www.youtube.com/watch?v=HcMHam54EOI

Click here to view on YouTube.

How to use the SDRPlay RSP as a panadapter

14 Replies

SDPlay-RSP

In this post, I will show you how to use an SDR as a panadapter for a commercial communications receiver. I’m using an Icom R72 and a SDRPlay RSP, but you can do it with nearly all receivers and SDRs.

The Icom R72 is a double conversion HF (0-30 MHz) communications receiver.

A panadapter lets you see the spectrum of your receiver (it gives you a broader, higher-level picture of what’s around your tuned frequency). After using it, you’ll wonder how you’ve been using your receiver without a spectrum display! 🙂

Almost all the radios we use are of superhetrodyne type. To connect a SDR to the radio, you should first find its 1st IF mixer output (if it has more than one Intermediate Frequency stage).

To find it, the best way is to consult the service manual. The first IF of Icom R72 is 70.4500 MHz, so we can use RTL-SDR dongles too.

Here’s a part of R72’s schematics, extracted from its service manual:

IC-R72-Schematic-Mehdi-Asgari

Look at the R82 resistor; it’s located at the output of first IF stage, so I soldered a connector to its pins (its other pin is connected to the ground)

Between the R82 resistor and the output, we’ve added a series 470-ohm resistor (to prevent loading the IF stage)

Click to enlarge.

The other side of this connector is connected to the antenna input of my SDRPlay RSP.

Now I can view my spectrum on a PC.

Here’s a screenshot of CubicSDR on Mac OS X (you can use other apps like HDSDR, SDR Console, etc.):

CubicSDR-Screenshot-Mehdi

Although this post was about the SDRPlay RSP and Icom R72, this procedure can be done for almost any combination of receivers and SDRs provided that your SDR covers the frequency of first IF stage.

Also, don’t forget that you should tune the SDR to the frequency of IF–in this case: 70.4500 MHz.

Mehdi Asgari, the author of this post, is a regular contributor to the SWLing Post. Mehdi lives in Tehran and is an active member of the EP2C amateur radio club.

eBay find: Mullard Meteor 600A

5 Replies

Mullard-Tube-Radio-Bakelite-1 Many thanks to SWLing Post reader, Monti, who knows that I have a serious affinity for 1940s era receivers. Monti writes from his home in Australia:

I had to send you this link Thomas. I’ve never seen this model before but what a stunning shape for a 40’s piece.

Look at this on eBay:
Mullard Meteor 600A Vintage Art Deco Bakelite Valve Radio c.1947

Lovely! While I could never pay $485.00 AUD for a non-working radio, I can certainly appreciate this gorgeous and unique design with radiating speaker grill louvres.

Check out this beautiful “meteor” dial:

Mullard-Tube-Radio-Bakelite-2

What a stunning radio!

Here are a few more pics I snatched from the eBay listing:

Mullard-Tube-Radio-Bakelite-3 Mullard-Tube-Radio-Bakelite-5

Mullard-Tube-Radio-Bakelite-4

Mullard-Tube-Radio-Bakelite-6

Thanks for sharing, Monti!

Any lucky SWLing Post readers in Australia or New Zealand own one of these Mullards?

Phil’s initial impressions of the Degen DE27

4 Replies

Degen-DE27

Many thanks to SWLing Post reader, Phil Ireland, who comments:

I’ve just received my Degen DE27 from China. Interesting little radio, I haven’t had a good chance to put it through its paces yet but my initial impressions are the radio seems well built and fairly intuitive to turn it on.

However, all the instructions are in Chinese so luckily there was someone in my office who could set the language to english otherwise, setting up the radio is a nightmare! I will have to take the radio outside to test its performance as the office environment is useless to listen in.

The box says the radio tunes from 3.2 mhz to 21.850 mhz however, I havent been able to work out how to make it tune out of the standard SW Broadcast Bands yet. Toggling between 10 khz and 9 khz steps for AM is easy as it setting the FM band coverage but I’m yet to determine the SW settings. It appears tuning is only in 5 khz as well on SW.

As for venturing into MP3 settings and recording, I’ll leave that, it seems too much of a challenge! The clock and calendar, sleep timer, alarms are all fairly straight forward but there is an “E-Book” setting which defies description! It has a USB flash disc function and inputs for a micro SD card. Charging the supplied Lithium battery is via a supplied USB cable.

The display is easy to read and attractive with excellent backlighting. I’m not expecting stellar performance on any band, after all, it was a cheap radio (about 40 AUD with free postage) but it is built around DSP architecture. Only a single bandwidth is available and there is no SSB capabilities. The radio hopefully will be ideal to throw onto a backpack or pocket as a travel portable.

If DEGEN read these comments, perhaps an English manual put online would be extremely helpful to allow users to get the most out of the DE27.

I’ll comment more on the performance later but for now, the radio shows promise.

Thanks so much for sharing your initial impressions, Phil! Please keep us informed as you discover more about this little radio!

This reminds me that I have yet to put my Degen DE221 through the paces. Stay tuned!